0110D005Bh3Hc Replace Oil Filter Element
View details
Product family
Brand-compatible hydraulic elements, stainless steel and fiberglass media elements, return / suction / pressure line elements and coalescer separators for hydraulic and lube systems.
Cross-referenced replacement elements for fourteen international hydraulic brands — matched by dimension, end-cap style and micron rating.
304 and 316L stainless steel mesh and sintered elements — cleanable, corrosion resistant, for high temperature and long service.
High-efficiency fiberglass and resin-impregnated paper media elements for hydraulic and lube oil service.
Elements located by circuit position — return line, suction strainer and pressure line service.
Coalescing and separating elements for oil-water separation in lube, turbine and process oil systems.
Model-matched lube and process oil elements for machine tools, injection moulding, turbines and general industrial equipment.
Engineering notes
Hydraulic and lube circuits fail from contamination faster than from mechanical wear. The element is the cheapest control point in the system — and the one most often bought wrong, matched on thread or housing rather than on micron rating, collapse pressure and media.
The range spans brand-compatible interchange elements, stainless steel and fiberglass media, elements located by circuit position (return line, suction, pressure line), coalescer separators for oil-water separation, and lube and process oil elements. Stainless elements in 304 and 316L are cleanable and return to service; disposable media is rated from 1 μm upward.
Fiberglass for fine filtration and high dirt-holding capacity; resin paper for general duty; stainless mesh and sintered media where the element is cleaned and reused.
1, 3, 5, 10 and 20 μm grades and coarser mesh are all held. State whether the requirement is absolute or nominal — the two are not the same number.
Outer diameter, length, end-cap and seal arrangement decide whether an element fits the housing. Thread, bayonet and clamp styles are all covered.
Return-line elements see surge flow, suction elements see inlet vacuum, pressure-line elements see full system pressure. The same micron rating in the wrong position still fails.
Brand names are used only to describe the platform an element is compatible with. JIANASH is an independent manufacturer of replacement filter elements and is not affiliated with, endorsed by or authorised by any of the original equipment manufacturers listed.
Yes, that is the normal route. Send the part number, or the element dimensions if the number has worn off. Cross-references are held for fourteen hydraulic brands, and the model page states the platform the element corresponds to.
No. They are independently manufactured replacement elements. Brand names appear only to describe which platform an element is compatible with; we are not affiliated with or authorised by those manufacturers.
Absolute rating is the largest particle that passes the element under the test method stated; nominal is a statistical efficiency figure. A nominal 10 μm element is not equivalent to an absolute 10 μm element, and quoting one when the machine specifies the other is the most common source of repeat failures.
Yes. 304 and 316L mesh and sintered elements are cleanable — backflush, ultrasonic or chemical — and return to service. We state the construction so the cleaning method can be confirmed before ordering.
Yes. Trial quantities and mixed-model consolidation are supported, which is usually the practical way to verify fit and rating before committing to a contract volume.
Get a quotation
We supply the full range — air compressor, hydraulic, dust, water, metal and gas elements. Send your list and we will cross-reference.
Fast quotation
One working day for a first answer. MOQ and lead time are stated with the quotation.
Open the inquiry form