10μm Stainless Steel Sintered Powder Filter Element
View details
Product family
Sintered wire mesh and powder sintered elements in 304 / 316L — cleanable, high temperature and corrosion resistant.
Multi-layer sintered wire mesh elements and filter discs, cleanable and reusable.
Sintered metal powder elements for fine filtration and high pressure service.
Engineering notes
Sintered metal elements are chosen where a disposable element cannot survive the duty: high temperature, high differential pressure, aggressive media, or repeated cleaning. The element is the filter — no paper, no binder, no separate housing insert to replace.
Elements in 304 and 316L: multi-layer sintered wire mesh elements and discs, and sintered powder elements for fine filtration under pressure. Ratings held run from 1 μm to roughly 500 μm depending on construction; interface, outer diameter and height are stated on each model page.
Sintered wire mesh is built from layered plain and twilled weave; powder elements are sintered for isotropic strength and finer absolute ratings.
Mesh construction is rated in micrometres and in mesh count; powder elements reach finer absolute ratings at lower flow rates.
Backflush, ultrasonic or chemical cleaning. Because elements are reusable, cost is per cleaning cycle rather than per element.
Thread, flange, clamp and open-end styles are held; outer diameter and height are stated per model so the element can be checked against the housing.
Brand names are used only to describe the platform an element is compatible with. JIANASH is an independent manufacturer of replacement filter elements and is not affiliated with, endorsed by or authorised by any of the original equipment manufacturers listed.
Wire mesh gives higher flow at a given differential pressure and is the usual choice for viscous oil and polymer service. Powder sintered reaches finer absolute ratings and is chosen for fine filtration under pressure. Both are cleanable.
It depends on the medium and the differential pressure the element is run at. The practical guidance is to clean on a differential-pressure trigger rather than on a fixed interval, and to replace when the clean differential pressure no longer returns to baseline.
Limits depend on construction, end-cap and seal, so they are stated per model rather than as a family figure. Confirm the duty — temperature, differential pressure, medium — before ordering.
Yes. Outer diameter, height, interface and rating can be built to a drawing or a sample, with the drawing confirmed before production.
Where an equivalent exists it is listed with the corresponding platform. Otherwise they are supplied as elements matched on geometry, interface and rating rather than as brand-labelled parts.
Get a quotation
We supply the full range — air compressor, hydraulic, dust, water, metal and gas elements. Send your list and we will cross-reference.
Fast quotation
One working day for a first answer. MOQ and lead time are stated with the quotation.
Open the inquiry form